Replacing the Main Hose (for Pre‑July 2019 Reels)

Note: These instructions apply only to hose reels manufactured before July 2019. Later models do not have this feature.

Steps to Replace the Main Hose

1. Lock the Hose in Place

• Lift the viewing panel.
• Pull the hose out to its full extension.
• Ensure the retraction wheel locks, preventing the hose from auto‑retracting.

2. Remove the Viewing Panel

• For easier access to the internal mechanism, remove the viewing panel completely.

3. Insert the Locking Bars

• Insert the locking bars into the nearest secure holes on the auto wheel.
• Ensure both bars (one on each side) are seated firmly before continuing.

4. Remove the Hose Clamp

• Unscrew both sides of the clamp holding the hose onto the auto retraction wheel.
• Remove the clamp and screws and set them aside safely.

5. Remove the Internal Hose Clip

• Take off the white plastic clip from the internal hose connector.

6. Detach the Hose Connector

• Disconnect the hose connector from the quick‑release snap‑on fitting.

7. Unscrew the Hose Connector

• Unscrew the connector from the hose.
• Keep all parts together to avoid losing small components.

8. Remove the Old Hose

• Pull the old hose back through the auto‑retraction guide hole.

9. Feed in the New Hose

• Thread the new hose through the guide hole, ready for attachment.

10. Reattach Components

• Reconnect the hose connector.
• Push the connector back onto the white plastic adaptor.
• Replace the hose clamp and screw it securely back into position.

11. Remove the Locking Bars

• Take the locking bars out of the retraction wheel.
• Store them inside the hose reel unit.

12. Release the Auto‑Retract Mechanism

• Gently pull the hose to release the locking mechanism.
• The reel should begin automatically winding the hose back into the unit.

When complete:
The hose reel should look like the image referenced—fully retracted and ready for storage.